Estimate Request for the image
S04320
To make a request for several images, go back to the
Picture Library
and add them to the Light Box.
Add to my light box
View my light box
Ref :
S04320
Theme :
Testings - Satellites - Probes - Rockets
(2314 images)
Title :
Lunar Landing Research Vehicle (LLRV) in flight
Caption :
In this 1965 NASA Flight Reserch Center photograph the Lunar Landing Research Vehicle (LLRV) is shown at near maximum altitude over the south base at Edwards Air Force Base.When Apollo planning was underway in 1960, NASA was looking for a simulator to profile the descent to the moon's surface. Three concepts surfaced: an electronic simulator, a tethered device, and the ambitious Dryden contribution, a free-flying vehicle. All three became serious projects, but eventually the NASA Flight Research Center's (FRC) Landing Research Vehicle (LLRV) became the most significant one. Hubert M. Drake is credited with originating the idea, while Donald Bellman and Gene Matranga were senior engineers on the project, with Bellman, the project manager. Simultaneously, and independently, Bell Aerosystems Company, Buffalo, N.Y., a company with experience in vertical takeoff and landing (VTOL) aircraft, had conceived a similar free-flying simulator and proposed their concept to NASA headquarters. NASA Headquarters put FRC and Bell together to collaborate. The challenge was; to allow a pilot to make a vertical landing on earth in a simulated moon environment, one sixth of the earth's gravity and with totally transparent aerodynamic forces in a ''free flight'' vehicle with no tether forces acting on it.Built of tubular aluminum like a giant four-legged bedstead, the vehicle was to simulate a lunar landing profile from around 1500 feet to the moon's surface. To do this, the LLRV had a General Electric CF-700-2V turbofan engine mounted vertically in gimbals, with 4200 pounds of thrust. The engine, using JP-4 fuel, got the vehicle up to the test altitude and was then throttled back to support five-sixths of the vehicle's weight, simulating the reduced gravity of the moon. Two hydrogen-peroxide lift rockets with thrust that could be varied from 100 to 500 pounds handled the LLRV's rate of descent and horizontal translations. Sixteen smaller hydrogen-peroxide rockets, mounted in pairs, gave the pilot control in pitch, yaw, and roll. On the LLRV, in case of jet engine failure, six-500-pounds-of thrust rockets could be used by the pilot to carefully apply lift thrust during the rapid descent to hopefully achieve a controllable landing. The pilot's platform extended forward between two legs while an electronics platform, similarly located, extended rearward. The pilot had a zero-zero ejection seat that would then lift him away to safety. Weight and balance design constraints were among the most challenging to meet for all phases of the program (design, development, operations).The two LLRVs were shipped disassembled from Bell to the FRC in April 1964, with program emphasis placed on vehicle No. 1. The scene then shifted to the old South Base area of Edwards Air Force Base. On the day of the first flight, Oct. 30, 1964, NASA research pilot Joe Walker flew it three times for a total of just under 60 seconds, to a peak altitude of approximately 10 feet. By mid-1966 the NASA Flight Research Center had accumulated enough data from the LLRV flight program to give Bell a contract to deliver three Lunar Landing Training Vehicles (LLTVs) at a cost of $2.5 million each. As 1966 ended, the LLRV #1 had flown 198 flights, and the LLRV #2 was being assembled, instrumented and cockpit modifications made at the South Base. The first flight of the number two LLRV in early January 1967 was quickly followed by five more. In December 1966 vehicle No. 1 was shipped to Houston, followed by No. 2 in mid January 1967. When Dryden's LLRVs arrived at Houston they joined the first of the LLTVs to eventually make up the five-vehicle training and simulator fleet. All five vehicles were relied on for simulation and training of moon landings.
to specify how you want to use these images. You can also send your request by
E-mail
To make a request for several images, go back to the
Picture Library
and add them to the Light Box.
Image(s) use :
----------- Specify usage --------------
Advertising
Advertising in Press
Press
Publishing
CD Rom-Internet
Movie-Video-TV
Non-commercial
Private use
Other, please specify
Reproduction format of the image in the final document :
----------- Specify format ---------------
Up to 1/8 page
Up to 1/4 page
Up to 1/2 page
Up to 3/4 page
Up to full page
Double page
Front or Back cover
Other, please specify
Print run of the document on which the image is reproduced :
----------- Specify print run ------------
1 to 100
101 to 500
501 to 1000
1001 to 2000
2001 to 2500
2501 to 5000
5001 to 10 000
10 001 to 25 000
25 001 to 50 000
50 001 to 100 000
100 001 to 500 000
500 001 to 1 000 000
Other, please specify
Number of consecutive uses :
--------- Specify number of uses -------
1
2
3
4
5
6
7
8
9
10
11
12
Other, please specify
If image is reproduced in the Press, please specify number of titles :
If image is reproduced as a poster
please specify size of the poster :
------- Specify poster format ---------
Up to 50 x 60 cm
Up to 80 x 120 cm
Up to 240 x 300 cm
Up to 360 x 480 cm
Other, please specify
Give all useful information or specify the use of the image(s) in this box :